Coulter Drill vs. Hoe Drill: Which Fits Your Ground?
Both drills put seed in the ground behind an air cart. The difference is how the opener gets there: a hoe drill pulls a narrow point through the soil, and a coulter drill slices it with a disc. Which one is right depends on your residue, your moisture and how much you want to disturb.
The short version
Lean hoe drill if you often seed into dry or hard ground, want the simpler and usually cheaper machine, or like some soil movement to warm and dry a cold seedbed.
Lean coulter drill if you direct seed into heavy standing stubble, want the least soil disturbance and moisture loss, or want to seed faster.
Side by side
| Hoe drill | Coulter (disc) drill | |
|---|---|---|
| How it opens | A knife or point on a shank pushes soil and residue aside | An angled disc slices residue and soil; a scraper holds the slot open |
| Soil disturbance | More. Some soil is thrown between rows | Least. A narrow slot with little soil thrown |
| Residue | Mixes more residue in; can rake and bunch long or viny straw | Leaves most stubble standing; can hairpin tough, damp straw |
| Dry, hard soil | Penetrates well and can reach down to moisture | Relies on frame weight and down pressure |
| Wet soil | Disturbance helps dry and warm the row | Slot can be harder to close; hairpinning risk goes up |
| Speed | Slower, to limit soil throw | Faster |
| Cost and upkeep | Usually lower. Openers are simple wear parts | Usually higher. Discs, bearings and scrapers wear |
Five questions that usually settle it
1. What does your seedbed look like at seeding time?
If you are often chasing moisture under a dry surface, a hoe opener's ability to move dry soil out of the row matters. If moisture is near the surface and you want to keep it there, a disc disturbs less of it.
2. How much residue, and how well is it spread?
Discs are at their best in standing stubble and at their worst in a wet mat of unevenly spread straw. Hoe drills clear moderate residue well but can plug or bunch in heavy, long straw. Either way, the combine's spreader does half the drill's work.
3. How do you place fertilizer?
Getting fertilizer near the row but below the seed is a big part of direct seeding in the inland Northwest. Both drill types can do it, with side-band openers on a hoe drill or mid row banders on either, so compare the whole fertilizer setup and not just the seed opener.
4. What crops are in the rotation?
Small-seeded crops reward the shallow, even depth a disc gives. If a planted row crop is in the mix, a coulter drill that can take a planter option may replace a second machine.
5. Who maintains it?
A hoe drill has fewer moving parts per row. A coulter drill has a disc, bearing and scraper on every opener, which is more to inspect each winter.
Where Bourgault's drills fit
- Hoe: the 3335 and 3545 ParaLink hoe drills (30 to 100 ft between them) and the simpler spring-trip 5810.
- Coulter: the 3725 for low-disturbance seeding and the 3820, which can also be set up to plant.
Sizes, spacings and options for each are on our Bourgault drills and air carts page.
Want a second opinion on your ground?
Spray Center Electronics is a Bourgault dealer in Spokane. Tell us your rainfall, rotation, residue and tractor and we will tell you which way we would lean and why.
Common questions
Is a coulter drill the same as a disc drill?
Yes. Bourgault calls its disc drills ParaLink Coulter Drills. The opener is a single angled disc with a scraper and seed boot beside it.
Which leaves more residue standing, a coulter drill or a hoe drill?
A coulter drill. A disc slices through residue and disturbs a narrow strip, while a hoe opener pushes soil and residue aside and mixes more of it in.
What is hairpinning?
Hairpinning is when a disc folds straw into the seed slot instead of cutting it, so the seed sits on straw instead of soil. It is most likely in wet, tough residue or soft ground, and good straw spreading at harvest helps prevent it.
Which drill is better in dry, hard ground?
A hoe drill usually gets into dry, hard soil more easily and can move dry soil aside to put seed into moisture. A coulter drill can do it too, but it depends on frame weight and down pressure.
General guidance, not a prescription for your field. Soil type, slope, rotation and timing all change the answer, and plenty of good farmers in the same county run different openers.