Pull-Type vs. 3-Point vs. Self-Propelled Sprayers: How to Choose

Every boom sprayer does the same job. What differs is what carries the tank: a trailer behind your tractor, the tractor's 3-point hitch, or a machine built for nothing else. That choice drives the price, the acres you cover in a day and what you can spray over.

The short version

Pull-type if you have a tractor free in spraying season and want the most capacity for the money.

3-point if your fields are small or awkward, your acres are modest, and your tractor can carry the weight.

Self-propelled if you spray over tall crops, cover a lot of acres, or cannot tie up a tractor.

Side by side

Pull-type 3-point mounted Self-propelled
Purchase cost Typically less than half of a comparable self-propelled Lowest Highest
Tank size Largest. Several thousand gallons on the big ones Smallest. Limited by what the tractor can lift In between
Working speed Moderate Moderate Fastest
Crop clearance Limited by the tractor and hitch Limited by the tractor Highest. Built to straddle tall crops
Maneuverability Needs room to turn; a steering hitch helps Best. Turns with the tractor Good
Needs a tractor Yes, for the whole spraying season Yes, and it has to carry the load No
Engine and drivetrain to maintain None of its own None of its own A second one on the farm

Pull-type sprayers

The tank and boom ride on their own trailer, so capacity is not limited by what a tractor can lift. That is why the biggest tanks on the market are pull-types, and a bigger tank means fewer stops to fill. The sprayer has no engine or transmission of its own, and if the tractor breaks down you can hook to another one and keep going.

The trade-offs are clearance and turning. You are limited to what the tractor can drive over, so late-season passes in tall crops are difficult. A trailed sprayer also cuts corners and needs more headland, which is what steerable hitches are for.

The cost comparison only holds if the tractor is already there. If you would have to buy or tie up a tractor to pull it, count that too.

3-point mounted sprayers

Everything hangs on the tractor's hitch. There is no trailer to track or back up, so a mounted sprayer goes anywhere the tractor goes, which suits small fields, odd corners, pastures and orchards. It is usually the cheapest way into a real boom sprayer.

The limit is weight. A full tank sits behind the rear axle, which unloads the front wheels, so tank size is capped by the tractor's lift capacity and ballast. Mounting and removing it also takes more effort than dropping a hitch pin. Some growers pair a mounted boom with a front tank or track tanks to carry more.

Self-propelled sprayers

A self-propelled sprayer is built around the job: high clearance, a cab positioned to see the boom, suspension tuned for speed, and no tractor to free up. It is the tool for spraying over tall crops and for covering very large acreages quickly.

You pay for that in purchase price, weight and fuel, and in one more engine and drivetrain to maintain. Speed also has to be managed, because drift gets worse when travel speed and boom height are not kept in check. Unless the cost is spread over a lot of acres, a custom applicator can be the cheaper way to get a self-propelled over your fields.

Five questions that usually settle it

1. Do you have a tractor free when it is time to spray?

If spraying overlaps with seeding or haying and the tractor is busy, a pull-type's price advantage shrinks.

2. How tall is the crop on your last pass?

Fungicide in headed wheat or a late pass in canola or corn is where clearance decides it.

3. How many acres between fills?

Application rate times acres gives the tank you need. At 15 gallons per acre, 1,000 gallons covers about 66 acres and 2,400 gallons covers a quarter section. Our tank mix calculator works out acres per fill for your rate.

4. How wet does your ground get in spring?

Weight and tire or track footprint decide how early you can get on. A big tank is only an advantage if the sprayer under it floats.

5. What do your fields look like?

Long, open runs favor wide booms and big tanks. Small, irregular or terraced fields favor something that turns tightly.

Whichever you choose

The carrier matters less than the plumbing and controls on it. Rate control, section control, boom height control and the right tips are what put the product where it belongs, and they can be fitted to any of the three. These tools help with that part:

Want a second opinion?

Spray Center Electronics in Spokane has built, plumbed and supported sprayers since 1985, and we are a dealer for FAST pull-type and 3-point sprayers. Tell us your acres, crops, tractor and how you spray now, and we will tell you which way we would lean and why.

Common questions

Is a pull-type sprayer cheaper than a self-propelled?

Yes, by a wide margin. A pull-type typically costs less than half of a comparable self-propelled sprayer, provided you already own a tractor that can pull it.

Can a pull-type sprayer cover as many acres as a self-propelled?

It can get close. A self-propelled sprays faster, but a pull-type usually carries a much bigger tank and so stops to fill less often. Acres per day depend on tank size, fill time and field shape as much as on speed.

When does a self-propelled sprayer make sense?

When you need to drive over tall crops late in the season, when you cover enough acres to spread the cost, or when you cannot spare a tractor during spraying season.

How big a 3-point sprayer can my tractor carry?

It depends on the tractor's rear lift capacity, hitch category and front ballast. A full tank is heavy and hangs behind the rear axle, so the front end gets light. Tell us your tractor and we will work out what it will carry safely.

What tank size do I need?

Multiply your application rate in gallons per acre by the acres you want to cover between fills. At 15 gallons per acre, 1,000 gallons covers about 66 acres and 2,400 gallons covers 160.

General guidance, not a prescription for your farm. Acres, crops, labor and the equipment you already own all change the answer.